SAE-Flare Fitting 1/4

ARMACELL SAE FLARE FITTINGS - Secure and Fast Solution for Split Installations

The Armacell SAE flare fitting meets the highest safety standards. It replaces the soldering in a fast, safe and economic way. No additional sealing is needed, only metal-to-metal sealing by the rim on the flare of the compression ferrule. The nut made of brass alloy fits perfectly on the tube armature, and the most important part -the compression ferrule- takes over the sealing much better than the traditional hand-made flared end to the copper tube very effectively. No copper gasket is needed and none of the pieces have to be replaced after maintenance and repair.

Secure and fast solution for split installations

Avoids the normal problems associated with traditional soldering

No special flare toolings needed

No hot working permit needed

Gas tight and highly resistant to mechanical damage

Complies with new CEN regarding refrigeration gases

Corresponds to the new standards and regulations of the CEN for refrigeration installations (EN 378/1 + EN 378/2 ).

Technical Features

No copper sealing necessary

Compression ferrule

Tight up to 10-7 mbar l /s respectively <= 0,5gr/a Helium for all refrigerants(CFC/HFC/HCFC)

Tight connection: no leaky connections, higher safety standard, meets test procedureDQJ/KP/926/99 developed by the refrigeration commission.

Meets the new standards EN378:2000 for refrigeration systems and heat pumps - Safety and environmental requirements - Part 2(design,construction, testing, marking and documentation).

Supervision & Certificates

Tested by internal test procedures according to DIN 3859 and by CETIM:

Reverse-bending strength test: no leakage after 10 Mio. cycles at 50 Hz under nominal pressure

Helium-leakage detector (gas tightness) : < 0,5 g/year (10-6 mbar/l/s)

Burst-pressure test (4 times nominal pressure): no leakage

Temperature cycle test (5 cycles at -40º C to +120 ºC at 10 bar He): no leakage CETIM, Internal and field test results